RSS Feed
Knowledgebase : Devices & Hardware > ACTA3 Hardware
WARNING: The Lowest FP Setting can be used to decrease the False Rejection Rate (FRR) of the ACTAtek when used with ID Match. This special setting is not enabled by default because its use may also increase the False Acceptance Rate (FAR). To offset t...
This document details the adjustment of the fingerprint scanner sensitivity on the ACTA3 generatation fingerprint capable readers. NOTE: These setting require firware version 3.06.1412 or greater! DISCUSSION The ACTAtek 3 genereation fingerprin...
DISCLAIMER This article may contain typographical and/or factual errors. Do not rely solely upon this article when determining the requirements of the Americans with Disabilities Act as it relates to the installation of the ACTAtek system. All informa...
DESCRIPTION: The ACTAtek allows for the "Door Strike #2" relay/contact to be used to activate an external bell or alarm. INSTRUCTIONS: The following instructions will demonstrate the use of the Bell Schedule feature: * Log into the ACTAtek's w...
INTRODUCTION: The Logiprint Remote Registration Device provides the ability to enroll userâ€(tm)s biometric data, or fingerprint, into an ACTAtek system using a Microsoft Windows based PC. Remote registration requires the use of the Logiprint FS80 fin...
DESCRIPTION: This article detail the use of a Password Reset Patch. The Password Reset Patch must be obtained from the reseller that sold the unit and may only be supplied to the original contact person within the organization. INSTRUCTIONS: The ...